LS swap trans cooler lines

[overpaid]

I have the ICT billet -6an fittings installed but I want to install the lines, at least the one end before I install the engine and trans ( I heard this is a must) but can someone show me a picture or tell me how they have them orientated.

Thanks!

 

[Jasons69Chevelle]

It doesn’t matter the orientation of the lines. I recommend a derale plate and fin style cooler. Tube and fin is less efficient. What transmission are your running? 4l60e will require some 180* fittings if I remember correctly. I can look tomorrow at the old transmission and engine are on a stand.

 

[Nashville Cat]

You need low-profile 90 degree fittings pointed towards the front of the car to clear the trans tunnel.
That's what I had to do for the 4L80e. I assume yours is the same.