It’s been so long that I can’t remember how the wire harness transitions from under the rear, driver side passengers seat to the back of the car.
I ran the AAW wires in the flat plastic conduit. My guess is that once it goes behind the panel that’s behind the seat, it jogs to the drivers side
and enters through a small hole at the front of the trunk. Does it simply climb up over the wheel hump as see seen in this pic?
From there I know how it’s routed, attached the the brace and then run along the underside of the trunk opening.
Thanks. (As you can see I had a bad outcome with the Guru truck spatter paint that came out like a fire hose. TOO BLUE.).
Is that hook on the driver side wheel well hump for the wire harness?
I ran the AAW wires in the flat plastic conduit. My guess is that once it goes behind the panel that’s behind the seat, it jogs to the drivers side
and enters through a small hole at the front of the trunk. Does it simply climb up over the wheel hump as see seen in this pic?
From there I know how it’s routed, attached the the brace and then run along the underside of the trunk opening.
Thanks. (As you can see I had a bad outcome with the Guru truck spatter paint that came out like a fire hose. TOO BLUE.).
Is that hook on the driver side wheel well hump for the wire harness?